Kenmore 25370319214 Use & Care Manual page 29

Before You Call (continued)
CONCERN l POTENTIAL CAUSE I COMMON SOLUTION
DISPENSER (ice & Water)
Dispenser wiff * Dispenser lock 0uf is engaged.
dlspense ice. , There is no icein the bin f0be
dispensedi
• Dispenser paddle has
' F
* PreSsand hold Control lock for three seconds'
* See the _!tce maker is not making any ice' Section ab0ve,
Be sure the refdgeraf0r doors are completely closed:
* The motor overload protector Will reset in about three
_ressed too long and the minutes and then ice can be dispensedi
dispenser motor has overheated:
Ice dispenser is * Ice has melted and frozen * Remove ice container, thaw, and empty the contents.
jammed, around auger due to infrequent Clean container, wipe dry, and replace in proper position.
use, temperature fluctuations, When new ice is made, dispenser should operate.
and/or power outages.
° Ice cubes are jammed between ice ° Remove ice cubes that are jamming the dispenser.
maker and back of ice container.
Dispenser Will n0f D!spenser !oc k out engaged; I *PreSS a nd hold control 10C k _or three sec0nds I
* Remove and reinstall the wafer filter. Be sure fo push the
fllter firmly so that yOUhear it lock sOlidly into position.
Replace filter cartridgel Be sure to remove protective Caps
and push the filter flrmly so that yOU hear it lack solidly
into position'
* Open household wate r line valve. See CONCERN column
open. AUTOMATIC ICE MAKER,
Wafer has an odd taste * Water has not been dispensed * Draw and discard 10-12 glasses of water to freshen the
and/or odor. for an extended period of time. supply.
* Unit not properly connected to * Connect unit to cold wafer line that supplies wafer to the
cold wafer line. kitchen faucet.
Wafer pressure Js * Cut,off and cut,on pressures are * Have someone turn up the cut,off and cut,on pressure on
extremely I tOO low (well SYstems Only): fhe ware i pump System (Well systemi Only)I
* Reverse osmosis system is in * It isnormal fora reverse osmosis system tO be below 20
' regenerative phase, psi during the regenerative phase.
Wafer not cold enough. * As warmer fop water goes * Add ice to cup or container before dispensing water.
through the filter and enters the
water tank the chilled water is
pushed through to the dispenser.
Once the chilled water is used
up it wiJJtake several hours to
bring the freshly replaced water
to a cooler temperature.
OPENING/CLInG OF DOORS/DRAWERS
Door(s) will not close. * Door was closed too hard, causing * Close both doors gently.
Drawers are
dlmCulf to
move.
other door to open slightly.
* Refrigerator is not level. It rocks
on the floor when moved slightly.
* Refrigerator is touching a wall or
cabinet.
' FOod is touching Shelf On fop of
drawer.
* Track that drawers slide on is dirty.
* Ensure floor is level and solid, and can adequately
support the refrigerator. Contact a carpenter to correct a
sagging or sloping floor.
° Ensure floor is level and solid, and can adequately
support the refrigerator. Contact a carpenter to correct a
sagging or sloping floor.
* Remove top layer of items in drawer.
* Ensure drawer is properly installed on track,
* clean drawer, rollers, and track: See Care& Cleaning'
29