Kenmore 25370319214 Use & Care Manual page 13

Installing Door Handles
Door Hancfle Mounting instructions
CAUTION
Wear gloves and safety goggles. Use ex|rerne CAUTION when installing these handles. The rounded end of the handles
may be sharp.
1. Remove handles from carton and any other protective packaging.
2. Position fresh food handle end over upper and lower pre-instaiied shoulder bolts (A) that are fastened into the doors
ensuring the holes for the set screws are facing towards the opposite door.
3. While holding handle firmly against door° fasten upper and lower Alien set screws (B) with supplied Alien wrench.
4. Repeat steps two and three to install opposite handle. Ensure the holes for the set screws are facing towards the first door.
5. Position freezer handle end over left and right pre-instaiied handle mounts that are fastened to the door° ensuring the holes
for the set screws are facing down.
6. While holding handle firmly against door° loosely tighten far right Alien set screw (B) with supplied Alien wrench until there
is no gap between handle and door.
7. Still holding the handle firmly to the door, firmly tighten far left Alien set screw (B) with supplied Alien wrench.
8. Return to the far right Alien set screw (B) and firmly tighten with supplied Alien wrench.
NOTE
Aii set screws should be tightened so that the screw is below the surface of the handle. The handles should be drawn tight to
freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Alien screw makes installation
easier.
The door handle may loosen over time. If this happens, tighten the set screws on the handles.
Mounting Refrigerator Handles Mounting Freezer Handles
m
13