Kenmore 25370319214 Use & Care Manual page 24

Changing the Filter
Locating the Filters
Your
refrigerator is equipped with water filtering system. The
water filter system filters all dispensed drinking water, as well
as the water used to produce ice.
Water Filter
The water filter is located at the top right side of the fresh
food compartment.
Replacing the Water Filter
In general, you should change the water filter every six
months to ensure the highest possible water quality. Wa|er
Filler S|alus on the user interface prompts you to replace the
filter after a standard amount of water (200 gallons/757
liters for Kenmorepure!
TM)
has flowed through the system.
If your refrigerator has not been used for a period of time
(during moving for example), change the filter before
reinstalling the refrigerator.
Ordering Replacement Filters
To order your replacement filters, please visit the dealer where
you purchased your refrigeraton Sears recommends that you
order extra filters when you first install your refrigerator, and
that you replace your filters at least once every six months.
Here is the product number to request when ordering:
Kenmorepure!
TM
Water Filter
Part #9999
NOTE
When ordering your replacement filter, please reorder
the
same filter type that is currently in your refrigerator.
More about your Advanced Water Filter
NS__ee he Kenmorepure!
TM
ice and water filter system
is tested and certified to NSF/ANSI Standards
42 and 53 for the reduction of claims specified
|on the performance data sheet.
Do not use with water that is microbiologicaiiy unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
Test & Certification Results:
* Rated Capacity - 200 gallons/757 liters for
Kenmorepure!
TM
ice and water filter
* Rated service flow - .50 gallons per minute
* Operating Temp.:/Vqn. 33°F, Max. 100°F
* Maximum Rated Pressure - 100 pounds per square inch
* Recommended Minimum Operating Pressure: 30 pounds
per square inch
To Replace your KenmorepureF M Water Fiffer:
It is not necessary to turn the water supply off to change
the filten Be ready to wipe up any small amounts of water
released during the filter replacement.
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the end/face of the filten
3. Slide the old water filter cartridge straight out of the
housing and discard it.
4. Unpackage the new filter cartridge. Using the alignment
guide, slide it gently into the filter housing until it stops
against the snap-in connector at the back of the housing.
5. Push
firmly until the cartridge snaps into place (you
should hear a click as the cartridge engages the snap-in
connector).
6. Press a drinking gloss ogoinst the woter dispenser while
checking for any leaks at the filter housing. Any spurts
and sputters that occur as the system purges air out of
the dispenser system are normal.
7. After filling one glass of water, continue flushing the
system for about four minutes.
8. Turn On the ice maken
9. Press and hold the Water Filter button on the Ice &
Water Dispenser control panel for three seconds. When
the display changes from Red to Green, the status has
been reset.
24