Table of Contents
Advertisement
7310 Installation and User's Guide
Installation
3. Installation
2
The following section details how to setup the 7310 IFL units
.
Setting up the 7310 IFL Transmitters and Receivers consists of the following
steps:
1. Setting up the transmitter.
2. Connecting the fiberoptic cable.
3. Setting up the receiver.
4. Powering the IFL.
5. Connecting the back panel jumpers.
6. Aligning the fiberoptic cable.
Observe all warnings and cautions mentioned at the beginning of this manual
(page 11). If after set-up you experience problems, refer to Trouble Shooting on
page 37.
Figure 6 - Typical Application of a 7310 IFL
2
This section gives instructions on installing the transmitter and receiver in a chassis rackmount.
For instructions on installing standalone units refer to Appendix II Installing a Standalone Unit.
Foxcom Proprietary Information
17
Document No. 93-005-39-A1
Advertisement
Table of Contents
