Assembly Instructions; Installing The Casters; Installing The Beer Tap - Haier HBF05E Installation Instructions Manual

English

Assembly Instructions

Read carefully and understand all installation instructions before installing the beer
dispenser. If after completing the process you are still unsure whether the beer
dispenser has been properly installed, we recommend that you contact a qualified
installer.

Installing the Casters

Follow the steps below to install the casters.
1. Empty the inside of the cabinet completely and
lay the beer dispenser down sideways. We
recommend that you place a piece of
cardboard or cloth underneath the cabinet to
prevent dents or scratches to the cabinet.
2. Insert the casters into the holes on the bottom corners of the cabinet. Tighten
each caster by turning the nut clockwise with the wrench provided.
3. Once all four casters have been tightened evenly, stand the cabinet in an upright
position.

Installing the Beer Tap

Follow the steps below to install the beer tap.
1. First, remove the cabinet plug located on the
worktop. Firmly grasp the cabinet plug, twist
and pull upward.
Note: Store this plug in a safe place as it will
be required when converting the beer
dispenser into a refrigerator.
2. Place the gasket over the wing nut on the
bottom of the beer tap.
3. Pass the beer tube through the gasket to the
base of the beer tap.
4. Push both the wing nut and the beer duct
through the hole in the worktop until the beer
tap is resting on top of the cabinet.
5. Align the holes of the beer tap with the gasket and pilot holes on the worktop of
cabinet.
6. Secure the beer tap to the cabinet by inserting four large Phillips-Head screws
into the holes and tightening.
7