Unpacking And Accessories Inventory - Haier HBF05E Installation Instructions Manual

Unpacking and Accessories Inventory

1. Remove all packing materials. This includes the foam base and all adhesive
tape holding the accessories both inside and outside. Slide out and remove the
plastic or foam guard used to secure the compressor during shipping.
2. Inspect and remove any remaining packaging, tape or printed materials before
turning on the beer dispenser.
Note: Allow the beer dispenser to stand in an upright position for 2 hours before
turning on the power.
Check all supplied accessories in the carton to be sure that all pieces are present
and in good condition. A checklist of accessories is listed below for your reference.
If you find any accessories that are not in good condition or are missing, please
contact our customer service department for assistance. Our Toll-Free number
is 1-877-337-3639.
1 Beer Tap Including:
1 Gasket for the Beer Tap
1 Washer for Connection to the Keg Coupler
1 CO Regulator
2
1 CO Cylinder
2
1 Keg Coupler
1 Cleaning Kit
1 CO Air Line
2
2 Hose Clamps
1 CO Cylinder Retainer
2
1 Guardrail
1 Drip Tray
4 Casters
1 Wrench
4 Large Phillips-Head Screws
8 Small Phillips-Head Screws
2 Retainer Fixing Screws
2 Wire Shelves
4 Support Pins
English
4