General Care & Cleaning; Cleaning Various Parts Of Your Oven - Kenmore 790.41003 Use & Care Manual

Electric built-in oven
Table of Contents

Advertisement

General Care & Cleaning

Cleaning Various Parts of Your Oven

Before cleaning any part of the oven, be sure all controls are turned OFF and the oven is COOL. REMOVE SPILLOVERS
AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE EXTENT AND
DIFFICULTY OF MAJOR CLEANING LATER.
Surfaces
Aluminum (Trim Pieces)
& Vinyl
Painted and Plastic,
Control Panel, Body Parts,
and Decorative Trim
Stainless Steel, Chrome,
Control Panel, Decorative
Trim
Porcelain Enamel,
Broiler Pan and Insert,
Door Liner, Body Parts
Oven Racks
Oven Door
DO Hand
Clean Frame
DO Hand
Clean Door
DO NOT
Hand Clean
Oven Door
Gasket
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth. Do not scour or use all-
purpose cleaners, ammonia, powdered cleaners or commercial oven cleaner. They can
scratch and discolor aluminum.
For general cleaning , use hot, soapy water and a cloth. For more difficult soils and
built-up grease , apply a liquid detergent directly onto the soil. Leave on soil for 30 to
60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any
of these materials; they can scratch.
To remove control knobs, turn to the OFF position; grasp firmly and pull straight off
the shaft. To replace knobs after cleaning, line up the flat sides of both the knob and
the shaft; then push the knob into place.
Before cleaning the control panel, turn all controls to OFF and remove the control
knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy water
and a dishcloth. Rinse with a clean water using a dishcloth. Be sure to squeeze
excess water from the cloth before wiping the panel; especially when wiping around
the controls. Excess water in or around the controls may cause damage to the
appliance.To replace knobs after cleaning, line up the flat sides of both the knob and
the shaft; then push the knob into place.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water
and a cloth. Do not use cleaners with high concentrations of chlorides or
chlorines. Always clean on the same direction as the stainless steel grain. Do not
use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for
cleaning stainless steel. Always be sure to rinse the cleaners from the surface as
bluish stains may occur during heating that cannot be removed.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1
solution of clear water and ammonia. If necessary , cover difficult spots with an
ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp
cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with a clean
cloth. Remove all cleaners or the porcelain may become damaged during future
heating. DO NOT use spray oven cleaners on the cooktop.
Oven racks, oven rack ladders and meat probe must be removed from
the oven during the self-clean cycle for cleaning. If they are not removed, the self-
clean cycle will damage the racks permanently, causing them to discolor and making
them difficult to slide. If this occurs, coat the racks with cooking oil to make them
easier to slide again.
Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse
well. You may use a glass cleaner on the outside glass of the oven door. DO NOT
immerse the door in water. DO NOT spray or allow water or the glass cleaner to
enter the door vents. DO NOT use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door.
DO NOT clean the oven door gasket. The oven door gasket is made of a woven
material, which is essential for a good seal. Care should be taken not to rub, damage
or remove this gasket.
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

790.42003

Table of Contents