Check For Messages; Remote Access Commands - VTech vt 1030 - V-tech Microphone Unidirectional User Manual

Check for messages

1. Dial your phone number. When you hear your outgoing message,
press . You will hear, "Please enter your security code".
2. Enter your 4-digit code and your machine announces
"You have (n) new messages". The new messages are
then automatically played back to you.

Remote access commands

When you have accessed your answering machine, you
can operate it using the keypad numbers on the phone
you are using.
The commands are:
Play remote access menu
Play all messages
Play new messages
Skip back to previous message
Delete current message
Skip forward to next message
Set answer only on/answer and record on
Play outgoing message
Record a new outgoing message
Set answer on/off
Answering machine
If you enter the incorrect PIN code,
you will hear "Incorrect security code".
You have two chances to enter the
correct remote access security code
before your VT1030 hangs up.
Time saver
If you have set the answer delay to
Time Saver, your answering machine
will answer after 2 rings
if you have new messages. If you do
not have new messages it will answer
after 6 rings. This enables you to hang
up if you hear more than 2 rings
before you are connected, saving you
the cost of a call.
If you do not press any button for 4
seconds, your VT1030
announces "Thank you for calling"
and then hangs up.
If you enter your security code
incorrectly, after the second attempt,
your VT1030 will announce:
"Thank you for calling" and will
hang up.
44