Weslo Pursuit T 39 Exercise Bike User Manual page 9

HOW TO USE THE CONSOLE
Before using the console, make sure that batteries
are installed (see assembly step 6 on page 6). If there
is a sheet of clear plastic on the display, remove the
plastic.
Follow the steps below to operate the console.
1
Turn on the console.
To turn on the
console, press
the On/Reset
button or begin
pedaling. The
entire display
will light for a
moment; the
console will then be ready for use.
2
Select one of the modes.
When you turn
on the console,
the scan mode
will be selected.
One indicator
will appear
below the word
SCAN to show
that the scan
mode is select-
ed, and a second indicator will show which mode
is currently displayed. Note: If you have selected
a different mode, press the Display button repeat-
edly to reselect the Scan mode.
Indicators
9
To select the
speed, time, dis-
tance, calories,
or fat calories
mode for contin-
uous display,
press the
Display button
repeatedly. The indicators will show which mode
is selected. Make sure that there is not an indica-
tor below the word SCAN.
Note: The console can display speed and dis-
tance in either miles or kilometers. The letters
"mph" or "km/h" will appear in the display to show
which unit of measurement is selected. To change
the unit of measurement, hold down the On/Reset
button for several seconds until the desired unit of
measurement appears in the display.
To reset the display, press the On/Reset button.
To pause the console, stop pedaling. When the
console is paused, the time will flash in the dis-
play. To continue your workout, simply resume
pedaling.
3
When you are finished exercising, the con-
sole will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few min-
utes, the console will turn off and the display will
be reset.