Table of Contents
Advertisement
Name of Parts
13
12
11
10
9
8
7
6
5
4
3
2
1
1.ON/OFF button
Used to turn on/off unit
2.Temperature display
3.Clock display
4.Timer ON/OFF display
5.Humidity display
6.Air filter cleaning display
When there is too much dust
collected on the air inlet, the
wire controller will show
this display to remind the
user to clean the air inlet.
After cleaning and installation,
*
just press the air filter reset button.
7.Super/Soft operation display
8.Fan speed display
Low Fan Med Fan High Fan Auto
9.Auto Swing display
10.Health state display
11.Fresh air state display
12.Humidifying state display
Note:
This model does not have the following related
1.
display and function
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The method
of calibration is:
1.Press ìClockî button, the Clock display ìAMî ìPMî will flash.
2.Press * or * to adjust time. For each press, the time will increase or
*
minute. If depressing the button, the time will increase or decrease
3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing,the
clock will begin to work.
14 15 16 17 18
19
MODE
FAN
SWING
AUTO
TEMP
SET
CLOCK
SLEEP
SET
TIMER
SUR
FILTER RESET
RESET
ON/OFF
13.Sleep state display
14.Network control display
15.Working mode display
Working
Auto
Cooling
mode
operation
operation
Wire
controller
16.Electric heating display
17.Operation mode button
Used to set working mode:
Auto, Cooling, Dehumidifying,
Heating, Fan
18.Fan speed button
Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto
19.Swing button
Auto
Used to set Auto Swing or
Fixed air sending direction
20.Temperature Setting button
Used to set temperature,
temperature range: 16*~30*
21.Clock button
Used to calibrate the time of
timer and clock
9
* *
10 11 12
16
20
21
22
23
24
25
26
27
28
Dehumidifying
Heating
Fan
operation
operation
operation
28
Wire Controller
22.Setting button
Used to confirm
the time of timer
and clock
23.Sleep button
Used to set Sleep
state
24.Time Adjusting
button
Used to adjust the
time of timer and
clock
25.Reset button
When the wire
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal
26.Air Filter Reset
button
After cleaning the
air inlet, press this
button, the unit
can start to operate
27.Timer button
Used to set the
mode of timer
28.Lock state display
*
decrease 1
*
rapidly.
3
Advertisement
Table of Contents
