Chapter 4 Led Indicators; Led Indicator Factory Default Behavior; Led Group Behavior; Led Tracking - PCS PO-KPCW6 User Manual

Upb 6-button controller

Table of Contents

Chapter 4

LED Indicators

The WMC6 has a total of six LED indicators that are placed behind the six

horizontal pushbuttons. These indicators can be used as a nightlight to

make the keypad easier to find in the dark. They can also be used in a

number of ways to indicate system status. This chapter will describe the

factory default operation of the LED indicators as well as how to use

UPStart to modify this default behavior to perform in a way that you desire.

When the 6-Button Controller is shipped from the factory it is pre-

configured to act as a default scene lighting system controller.

To support the default scene lighting system controller, the LED indicators

are configured to light up (to maximum brightness) the last pushbutton that

is pressed. All other LED indicators extinguish in such a manner that only

one LED will be turned on at a time.

Furthermore, the 6-Button Controllers are configured such that the LED

indicators on multiple 6-Button Controllers will track one other. This

means that if the 'A' pushbutton is pressed on one controller the 'A' LED

indicator will illuminate on all 6-Button Controllers.

The 6-Button Controller has a pushbutton keypad that can faintly light up to

allow it to be more easily seen in the dark. This is known as Keypad

Backlighting. By default Keypad Backlighting on the 6-Button Controller

is enabled.

The 6-Button Controller has pushbuttons that light up when certain events

occur. The Controller allows you to choose between five brightness levels

(including off) to have the pushbuttons light up to. The pushbutton

indicator brightness can be set to High, Medium, Low, Faint, or None. By

default the Indicator Brightness on the 6-Button Controller is set to High.

The UPB 6-Button Controller User's Guide

Table of Contents