Subscribe to Our Youtube Channel
Related Manuals for PCS WMC6
Summary of Contents for PCS WMC6
- Page 2 Retain these instructions for reference or download the manual from www.pcslighting.com. Important Notes Prior To Installation CAUTION: Before installing the WMC6 into a wall box, be sure that power to the wall box has been disconnected by removing the fuse or turning the circuit breaker off. Installing products...
- Page 3 Lighting System devices and be able to see its pushbuttons light-up for feedback. The WMC6 (see Figure 1) has six pushbuttons normally labeled ON, A, B, C, D, and OFF (see NOTE below) with LED backlighting and two buttons (UP and DOWN) without backlighting. All...
- Page 4 Make sure all wire connections are tight and that no bare copper is exposed. 3) Install the WMC6 into the wall box using the following steps: a) Install the WMC6 into the wall box, making sure all wires are neatly installed. Verify the ON button is at the top.
- Page 5 Using Your 6-Button Controller This section will describe the operation of the 6-Button Controller in its factory default configuration. The 6-Button Controller is packed full of different options and configurations that can be programmed into it using a UPB Setup Tool. Please refer to the section entitled “Configuring the 6-Button Controller”...
- Page 6 UPB™ Setup Tool. Please refer to the UPB Lighting System User’s Guide on the PCS web site for instructions on how to change the 6-Button Controller’s configuration. Table 1 describes the many configuration options available that can be set up with the use of a UPB™...
- Page 7 Option Factory Default Possibilities ON Pushbutton Button Mode = Configure any of 15 different UPB Messages UPB Transmissions On Button to be transmitted upon each of four Link = 001 Pushbutton Events to any of 254 Link IDs. OFF Pushbutton Button Mode = Configure any of 15 different UPB Messages UPB Transmissions...
-
Page 8: Setting Factory Defaults
Changing A Scene’s Preset Light Levels The PCS 6-Button Controllers are specially designed to work in a UPB™ Lighting System consisting of WS1D Wall Switch Dimmers. Pushbuttons on these controllers can be configured to activate the Preset Light Levels and Fade Rates stored in the WS1D (scenes). Once configured, the homeowner can easily adjust the Preset Light Level that gets activated by a particular pushbutton by following this simple procedure. -
Page 9: Specifications
SPECIFICATIONS Model Number WMC6 DTC6 Number of Backlit Pushbuttons UP/Down Pushbutton IR Remote Receiver Future Future Plastic Case None Connections 16 GA Power cord supplied Dimensions 4.1 X 1.7 X 1.8 in 4.3 X 2.6 X 0.9 in Weight 0.3 lb.
Need help?
Do you have a question about the WMC6 and is the answer not in the manual?
Questions and answers