Table of Contents
Advertisement
Laipac Technology Inc.
M2M 3350 User's Manual & Reference Guide
Finally, a message window will appear at the bottom of the screen: "Your new hardware is
installed and ready to use".
If the "Found New Hardware Wizard" appears again, follow the instructions again as above to
complete the installation.
3.4
Creating a Modem Profile for the M2M 3350
If you are using the modem in USB mode, make sure the selector switch on the front of the
modem is set to 'USB'. If you are using the serial or Bluetooth option, make sure the selector
switch is set to 'COM'.
!!If you are using the Bluetooth option, skip to section 3.6!!
In order to know which comm. port the modem is emulating for USB we need to open Control
Panel>System>Hardware>Device Manager>Ports and see which port the modem is using. In
this case it is 'CP210x USB to UART Bridge Controller (COM 4)' as shown below.
© 2002-2007 by Laipac Technology Inc. All Rights Reserved.
Page 8
Advertisement
Table of Contents
