notice. All statements, information, and recommendations in this manual are believed to be accurate but are represented without warranty of any kind, express or implied,
users must take full responsibility for their applications of any Products - Reproduction of the contents of this manual, in whole or in part, without written permission of
GSM coverage. Using a SIM card you can download emails, surf the web, send/receive SMS, send faxes, and make phone calls from your PC while on the road. The M2M 3350 uses the power from your USB port so it does not require any external power supply. You can connect to the M2M 3350 using USB, RS232, and Bluetooth (Optional).
Laipac Technology Inc. M2M 3350 User’s Manual & Reference Guide CONFIGURATION AND SETUP This section will help you setup a connection for your M2M 3350 using Windows XP. What you will need To begin you will need the following: • M2M 3350 •...
M2M 3350 User’s Manual & Reference Guide USB Driver Installation Put the M2M 3350 CD into your computer and make sure the modem is not connected to the PC. Click ‘USB Driver Install’ and follow the instructions. After the pre-installation has finished, connect the M2M 3350 to your PC using the USB cable.
If the “Found New Hardware Wizard” appears again, follow the instructions again as above to complete the installation. Creating a Modem Profile for the M2M 3350 If you are using the modem in USB mode, make sure the selector switch on the front of the modem is set to ‘USB’.
Dongle is set towards the antenna and not towards the DB9 connector as shown below. Make sure the Bluetooth Serial Dongle is connected to the serial port on the M2M 3350. Note the COM port as discovered from section 3.7.
Pairing your Bluetooth Devices (Optional) Once the drivers are installed, you may continue with the setup. Press ‘Next’ to continue installing the other components and pair your existing Bluetooth device with the M2M 3350 Serial Bluetooth Dongle. Be sure to install all of the components. All should be selected by default. Press ‘Next’.
Page 18
Once the Bluetooth dongle has been setup you can search for devices. With the Bluetooth USB dongle plugged in, connect the RS232 Bluetooth module to your M2M 3350 serial port and power on both units. Make sure the selector switch on the Serial Bluetooth dongle is set to ‘Port’ and not ‘Adapter’.
SIM CARD RECOMMENDATIONS If you will be using the M2M 3350 primarily for data transferring such as surfing the internet or downloading email it is best to have a large or unlimited GPRS data plan. If not, you may be charged for data over usage at a much higher rate.
M2M 3350 User’s Manual & Reference Guide OPERATION Every time you use the M2M 3350 you should make sure that all other internet connections are disabled. You will most likely need to connect to the modem before each use if you often disconnect it from the PC.