Nexgrill Liquid Propane Gas Grill Assembly & Operating Instructions page 11

Installing Battery
1.Unscrew the ignition battery cap. (Found at far left of
control panel).
2.Install battery into ignition box with positive terminal
facing outward.
3.Replace the ignition battery cap after the battery has
been installed. (Fig.16)
When you have finished assembling grill, make
sure that all screws and nuts are tight and secure.
Installing Side burner Pipe and Side burner control
panel bracket:
1.Unscrew the 2 screws which one screwed on the
Side burner control panel bracket, the other one
screwed on the side burner pipe bracket A..
2. Then install the long bracket as right pix shown,
which connect side control panel with the side burner
bracket A.
Installing Grease Cup
Attach the greasy tray heat shield to greasy slide
panel using (2)5/32 x10mm. flat head screws. And (2)
5/32 flat washer(silica gel)（Fig.17)
From grease back to pull out grease tray, remove the
packaging materials from it, then insert grease cup
into grease tray as shown (Fig.18). Push grease tray
back to grill.
Installing Cooking Components
Important: Before cooking on your grill the first time,
wash cooking grids and cooking rack with warm ,
soapy water. Rinse and dry thoroughly. Season with
cooking oil regularly. After cooking is completed, turn
grill to HIGH setting for 3 to 5 minutes to burn off
excess grease or food residue.
1. Install heat diffusers above burners. Holes in rear
corners of diffusers attach onto pegs in the back
ledge of firebox. Ensure that grill head heat shield is
inserted securely into slots. If grill was shipped with
shield taped in place, remove tape before using grill.
2. Evenly space cooking grids on the ledge above
heat diffusers. (Fig.19)
3. Insert legs of warming rack into the holes in the
top of grill bowl side panels. (Fig.19)
Figure 16
Figure 17
Figure 18
Figure 19
11
3 0 0 4 0 0 5 00
2 00 6 0 0
1 0 0 7 0 0
8 0 0
3 00 4 00 5 00
60 0
20 0
1 00
8 00 70 0