Bodypack Transmitter - JBL EVOi.sys User Manual

M I C R O P H O N E

Bodypack Transmitter

4
Security Cover
Protects the and
POWER MIC
actuated unintentionally.
5
MIC
Slide the switch to to mute the audio signal while power
0
and carrier frequency remain on. Thus, no noise will become
audible if you mute the microphone, even if the
control on the EVO wireless receiver is set to minimum.
6
POWER
Slide the switch to turn the transmitter power on (
7
Status LED
Indicates battery status and audio input overload. If the LED
is constantly lit, the batteries will be dead in about 90 min-
utes. If the LED flashes, the audio input is being overloaded.
8
Audio Input
3-pin male mini-XLR connector for connection to the EVO
Lavaliere Microphone.
9
Antenna
Permanently connected, flexible antenna.
10
GAIN
Use the rotary control to match the microphone's level to
GAIN
the transmitter's audio section. It is also accessible when the
battery door is on.
11
CHANNEL
Use the rotary switch to select a desired carrier
CHANNEL
frequency for transmission.
IMPORTANT: Be sure to switch POWER to off before
selecting a CHANNEL.
12
Belt Clip
Use the Belt Clip to attach the transmitter to your belt in one
of four ways, as shown in Figure 5 (on the right).
13
Carrier Frequency Table
A label lists available frequencies and is affixed to the rear
panel of the bodypack transmitter.
switches from being
SQUELCH
) or off (
I 0
O P E R A T I O N
).
Figure 5 The Belt Clip can be positioned on the EVO Bodypack
Transmitter in four ways.
14
Frequency Set Designation
The same label (on the rear panel) also indicates the
designation of the Frequency Set.
15
Battery Compartment
See Setting Up on page 8
16
Battery Door
See Setting Up on page 8
12
12
23