Master Section - JBL EVOi.sys User Manual

M I X E R
7
6
1
2
3
4
L SUB R
14
O P E R A T I O N
12
13
8
9
10
14
15
16
17
18
19
20
5
L MIX R
21

MASTER SECTION

1 AUX OUTPUT MASTERS
Each of the three auxiliary outputs (
ter level control which sets the output level of the combined
auxiliary signals from the channels, and an associated
(After Fader Listen) switch. Just as a channel's
allows pre-fade listening, you can monitor each auxiliary output
after the level control by pressing the
what level is leaving the output connector. This routes the aux-
iliary output signal to the
MONITOR
replacing any existing signal which is selected. The console
will also switch from the selected source to display the
METERS
PFL/AFL signal and the
PFL/AFL
or switch is pressed. When you release the switch the
PFL AFL
MONITOR returns back to the previous source.
2
LEX FX MASTER
The master control sets the overall level of the effects
LEX FX
sends from the channels before the input of the Lexicon
Digital Effects Processor. An associated
signal to be monitored in the same way as the auxiliary masters
(see above callout).
NOTE: When the LEX FX AFL switch is pressed, the meters become the
Lexicon Input level indicators.
3 SUB TO MIX
The submaster mix may be used to provide alternative outputs
from the mixer or, by pressing
master faders may be used as audio subgroups.When
is selected, the combined level of input channels are
MIX
added to the main mix under the control of a pair of faders.
4
L SUB R (Master) Faders
The (master) faders set the final level of the submaster
L SUB R
L and R outputs. Assuming input
correctly set, the (master) faders should be set close to
L SUB R
the ' 0 ' mark to provide maximum travel on the faders for
smoothest control.
AUX1 ~ AUX3 ) has a mas-
AFL
switch
SOLO
switch to determine
AFL
or circuits,
PHONES
LED lights to warn that a
AFL switch allows the
SUB TO MIX , the SUB L and R
SUB TO
settings have been
SENS