Table of Contents
Advertisement
12
Technical data
Problem
The temperature in the re-
frigerator is too high.
Replacing the lamp
1. Disconnect the mains plug from the mains socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new lamp
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains socket.
8. Open the door. Make sure that the lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Possible cause
There is no cold air circulation
in the appliance.
Height
850 mm
Width
595 mm
Depth
635 mm
S51700TSX0
S71700TSW0
850 mm
595 mm
635 mm
Solution
Make sure that there is cold air
circulation in the appliance.
S71700TSX0
850 mm
595 mm
635 mm
Advertisement
Table of Contents
