Convert Event Types To Action Rules; Setting Up An Action Rule - Axis M1054 User Manual

AXIS M1054 Network Camera
Events
Activate Light — turn the built-in light on or off.
•
Output Port — activate an I/O port to control an external device.
•
Play Audio Clip — see Audio Clips, on page 21.
•
PTZ Control
•
- Preset Position — go to a preset position.
Guard Tour — start a guard tour, see Guard Tour, on page 26.
-
• Record Video — record video to a selected storage.
Send Images — send images to a recipient.
•
Send Notifications — send a notification message to a recipient.
•
• Status LED — flash the LED indicator. This can for example be used to validate triggers such as motion detection during
product installation and configuration.

Convert Event Types to Action Rules

If the Axis product is upgraded to firmware version 5.40 or later, it is recommended to convert Event Types to Action Rules. The
legacy user Event Types in the camera will continue to work but will not be visible in the user interface of the camera. The Event
Types need to be converted to Action rules to become visible in the user interface.
To convert Event Types to Action Rules go to Events > Action Rules and click Convert.
Caution
This is not recommended when using a VMS based on the old Event Management System.

Setting Up an Action Rule

An action rule defines the conditions that must be met for the product to perform an action, for example record video or send email
notifications. If multiple conditions are defined, all must be met to trigger the action.
The following example describes how to set up an action rule to record video to a network share if there is movement in the
camera's field of view.
Set up motion detection and add a network share:
1. Go to Detectors > Motion Detection and configure a motion detection window, see page 29
2. Go to System Options > Storage and set up the network share, see page 44.
Set up the action rule:
1. Go to Events > Action Rules and click Add.
2. Select Enable rule and enter a descriptive name for the rule.
3. Select Detectors from the Trigger drop-down list.
4. Select Motion Detection from the drop-down list. Select the motion detection window to use.
5. Optionally, select a Schedule and Additional conditions, see below.
6. Under Actions, select Record Video from the Type drop-down list.
7. Select a Stream profile and configure the Duration settings as described below.
8. Select Network Share from the Storage drop-down list.
33