Troubleshooting By Led And Buzzer Indicators Diagnosis - Argox OS-2130D User Manual

Troubleshooting by LED and Buzzer Indicators
Diagnosis
Normally, when the printer is in not working properly, the "Power"
LED blinks continuously, and printing and communication
between the host and printer stops. Refer to LED indications
listed below to understand possible solutions to resolve the
problems printer may run into.
LED Indicators: Power and Ready LEDs blink at the same tempo
Power LED Ready LED
ON ON
OFF OFF
Possible Problems Solutions
Media sensor cannot Check the label path
index label gaps
Check the label sensor
Media out Install a new label roll
Paper jam Recover the jam
16
OS-2130D & OS-2130DE User's Manual
Remarks
If a continuous label roll
is in use, set
"continuous media"
printing in driver
settings or commands.
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems Solutions
Serial IO error Check serial baud rate at
both of your system and
the printer.
Cutter has failed, or Check the cutter or
there is paper jam recover paper jam.
inside the cutter.
Other possible Contact the reseller for
hardware errors. further service.
LED Indicators: Only the Ready LED blinks
Power LED Ready LED
ON ON
ON OFF
Possible Problems
Print head needs to Printing will stop until the print head cools to
cool down normal printing temperature.
Once it completes, the printer will
automatically resume the printing tasks sent
previously.
OS-2130D & OS-2130DE User's Manual
Remarks
For serial interface only
Only applicable when
cutter mode to cutter
mode.
Solutions
17