•
The picture at right shows the position of the
perforated metal plates (1) and the fixation
bolts (2) of the retaining plates for adjusting
the seat height and seat angle.
The picture at right shows the front perforated
metal plates. The procedure is similar for the rear
perforated metal plates. To adjust the front
perforated metal plates, an open-end spanner 13
mm is needed in addition to the Allen key 5 mm.
•
To adjust the seat height/seat angle, loosen
and remove the bolt (1), using the spanner.
•
Adjust the perforated metal plates to the
desired height/angle.
•
Re-position the bolts again and tighten with
the spanner to 40 Nm.
42