M3 Mobile M3 Green MC-6300S User Manual page 35

Via GPRS/EDGE (2)
How to connect the GPRS/EDGE manually
Start / Settings / Network and Dial-up Connections or Control Panel / Network and Dial-up Connections.
–
Select make new Connection. Enter the name of connection. check dial-up connection, and press next. (ex. Make Name:GPRS)
–
Select Hayes Compatible on COM1
–
Press [configure..], and set [Device properties] . [
–
Port Settings Tab :
Set a Baud Rate to 460800. other data remain as the picture below.
Call Options Tab :
On Extra settings Enter special modem commands "+CGDCONT=1","IP","apn_name" then press OK.
After done with configuration, input "*99***1#" in the 'Phone number' edit box and leave all the rest untouched. As last press
–
'Finish' button.
Now the connection icon would have been generated on the 'Network and Dial-UP Connections' Window as the picture below.
–
On the window which pops up by double-clicking on this icon, user needs to input the username and the password, provided
by the SIM card or Network provider.
Check mark " save password", then press "connect" to finish Internet setting After using Internet, press C ec a
–
taskbar to disconnect
On the internet explorer, select View >Internet Options and under Autodial name on the Connection Tab, you can choose the
–
name which has been generated. If the configuration setting was not correct, the name would not be displayed.
Now you can use internet just by running Internet Explorer without extra procedure for Dial-Up Connecting.
–
This way of setting is used when there is GPRS/EDGE module installed, but the user does not
want to use the mobilecompia's phone program or there is no phone program installed.
35
g ], [ p p
g , p
sa e pass o d , t e p ess co
]
ect to s te et sett g te us g te et, p ess butto button from
p
o