Universal Garage Door Opener (Homelink ) - Jeep Compass 2014 User Manual

ELECTRONICS
Auto Door Lock
• To have the doors lock automatically when the vehicle's speed exceeds 15 mph
(24 km/h):
• Enter your vehicle and close all the doors.
• Cycle the ignition switch between LOCK and ON and then back to LOCK four
times, ending up in the LOCK position (do not start the engine).
• Press the power door LOCK switch to lock the doors. A single chime will indicate
that programming is complete.
Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flashing Lights With Lock
• The turn signal lights flashing, when the doors are locked or unlocked, feature can
be turned on or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than 10
seconds. Then, press and hold the LOCK button while still holding the UNLOCK
button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink replaces up to three hand-held transmitters that operate devices such
®
as garage door openers, motorized gates, lighting or home security systems. The
HomeLink ® unit is powered by your vehicles 12 Volt battery.
• The HomeLink ®
designate the three different HomeLink
• The HomeLink
®
Before You Begin Programming
HomeLink®
• Ensure that your vehicle is parked out-
side of the garage before you begin
programming.
• For efficient programming and accu-
rate transmission
frequency signal, it is recommended
that a new battery be placed in the
hand-held transmitter of the device
that is being programmed to the
HomeLink ® system.
58
buttons that are located in the overhead console or sunvisor
indicator is located above the center button.
of the radio-
® channels.