Specifications - Grundig 800 MILLENNIUM Use And Care Manual

Frequency Range: 100 to 30.000 kHz (0.1 to 30 MHz).
87 to 108 MHz, 118 to 137 MHz.
AM. USB. LSB modes (0.1 to 30 MHz).
AM mode only for 118 to 137 MHz.
FM mode only for 87 to 108 MHz.
Sensitivity - SSB
(10 dB S+N/N): Less than 0.5 uV, 0.1 to 30 MHz.
Sensitivity - AM
(10 dB S+N/N): Less than 2.0 uV. 0.1 to 30 MHz.
(1000 Hz. 30% Mod): Less than 4.0 pV, 118 to 137 MHz.
Sensitivity - FM
(20 dB S/N) (monaural): Less than 4 uV, 87 to 108 MHz.
Frequency Stability 10 ppm, 0C to 50C
Frequency Accuracy: Better than 100 Hz. c 25' C
Selectivity - SSB. AM: 6 kHz c -6 dB, less than 12 kHz 0 -60 dB.
4 k H z c - 6 d B . l e s s t h a n 9 k H z c - 6 0 d B .
2.3 kHz c -6 dB, less than 5 kHz c -60 dB.
IF Frequency - SSB. AM: 1st IF. 55.845 MHz.
2nd IF, 455 kHz.
1st IF. 10.7 MHz (Single Conversion).
FM:
Greater than 60 dB. 0.1 to 30 MHz
Image Rejection:
Greater than 60 dB, 118 to 137 MHz.
Greater than 50 dB. 87 to 108 MHz
Greater than 80 dB. 55.845 MHz.
IF Rejection.
Greater than 80 dB. 455 kHz.
IP3 - Intercept Point
(@± 50 Ohm Ant. Input)
(Attenuator Off):
Greater than +10 dBm @ 100 kHz spacing.
Greater than -20 dBm Q 5 kHz spacing.
AGC Performance Threshold: 1 0 uV
Attack Time. 1 mSec.
Release Time: SLOW. 3 sec
Less than 6 dB change in audio output for
90 dB RF input change (referenced from the
AGC threshold point plus 3 dB).
56 3/4" (1.414 meters) telescoping whip
(for use on all bands).
Internal Antenna
Ferrite rod antenna
(For use from 100 kHz through 1800 kHz)
0 1 to 30 MHz. 50 Ohm SO-239 connector
or 2 terminal compression connector for
External Antenna Inputs 500 Ohm input with ground
87 to 108 MHz and 118 to 137 MHz
75 Ohm "F" type connector
1 Watt each nominal into two 4 Ohm speakers
with 9 VDC supply voltage External jack is
1/4" (6.35 mm) and two-way for stereo output
External Speaker Output
2 Watts nominal when neither headphones
nor external speakers are plugged in
Power to Internal Speaker: 4'(10 16 cm), 4 Ohms.
Internal Speaker

SPECIFICATIONS

FAST. 300 mSec
Line Audio Outputs:
Stereo left and right.
300 mV. 4.7K Ohms for each output.
Headphone Jack: 1/8 inch (3.175mm) stereo/mono type.
DC Power Requirements: Input: 7-10 VDC 0 1 Amp. supplied from
AC ADAPTER, external DC Power
Supply or 5.7 to 9.0 VDC supplied by (6)
internally mounted "D" cell (1.5V)
batteries (not supplied).
Current requirements
(approximate) from
9.0 VDC Supply or
Batteries with 1/4 W
average Audio Output:
Mode Dependent:
510 mA minimum with lamp off,
830 mA maximum with lamp on.
0C to +50C
Operating Temperature:
Weight: 14.55 lbs. (6.6 kg). including
AC ADAPTER, (batteries NOT included).
Size - Width: 20 -7/8" (53.575 cm).
Height: 9-1/4" (23.495 cm) with handle retracted.
Depth: 8 1/2" (21.59 cm) including front handles.
Supplied AC ADAPTER
Input:
120-230 VAC auto switchable. 50/60 Hz
with dual switchable plug wires.
Output: 9 VDC @ 1500 mA maximum.
Center conductor of connector is
positive.
4