Shortwave 'Meter' Band Designator Entry; Frequency Resolution; Front Panel Lock (Unlock); Am Syncronous Operation - Grundig 800 MILLENNIUM Use And Care Manual

SHORTWAVE 'METER' BAND DESIGNATOR ENTRY To
facilitate tuning to particular sections of the shortwave band
that contain many worldwide
information and music, the SATELLIT 800 MILLENNIUM
permits entry of the 'METER' band designator. In some
cases, the worldwide broadcast station may not announce its
exact operating frequency, but will announce the 'METER'
band in which it is operating or to which band it will move to
improve worldwide reception at a particular time of day. By
entering this 'METER'
automatically tunes to the low frequency end of the
corresponding 'METER' band. The search for the new
station location is thus limited to a particular smaller section
of the entire shortwave band spectrum. The Shortwave Band
Designators and corresponding frequency ranges are as
follows:
S h o r t w a v e B a n d D e s i g n a t o r s
Band Low Freq
120 Meter 2300 kHz
90 Meter 3200 kHz
75 Meter 3900 kHz
60 Meter 4750 kHz
49 Meter 5950 kHz
41 Meter 7100 kHz
31 Meter 9500 kHz
25 Meter 11,600 kHz
22 Meter 13,570 kHz
19 Meter 15,100 kHz
16 Meter 17,480 kHz
13 Meter 21,450 kHz
11 Meter 25,600 kHz
Press the 'BAND' button as required to enter the shortwave
band tuning mode. At this point, you can enter a frequency
with the 'Direct-Key-Input' buttons, or use the TUNING knob
and/or the and buttons to change frequency.
To enter a shortwave band 'METER' designator, press the 'SW
BAND' button to display a flashing 'METER' number entry
prompt. The prompt will flash for approximately 3 seconds
after the SW BAND button is pressed. While it is still flashing,
enter one of the listed two or three digit Band numbers
corresponding to the desired 'METER' band designator using
the 'Direct-Key-Input' buttons. While the 'METER'
annunciator is flashing, the
be used to step quickly from band to band. After selection of
the 'METER' band, use the TUNING knob or
buttons to change the frequency, or press the 'Direct-Key-
Input' keys to make a direct frequency entry.
GETTING STARTED, cont'd.
broadcasts of news,
band number, the receiver
High Freq
2500 kHz
3400 kHz
4000 kHz
5060 kHz
6200 kHz
7600 kHz
9900 kHz
12,100 kHz
13,870 kHz
15,800 kHz
17,900 kHz
21,850 kHz
26,100 kHz
and buttons can also
a n d

FREQUENCY RESOLUTION

The SATELLIT 800 MILLENNIUM tunes in the
following steps:

FRONT PANEL LOCK (UNLOCK)

All keyboard entries, display settings, and entries from the
tuning knob can be locked if desired. First, be sure the
SATELLIT 800 MILLENNIUM is not in SCAN mode.
Press and hold the
Key-Input' keys. The LOCK annunciator will light indicating
the front panel controls are LOCKED out. POWER on/off will
still function as well as VOLUME, BASS, TREBLE, and AIR
BAND SQUELCH. Press and
hold the button to unlock. The LOCK annunciator will
extinguish, indicating the front panel controls are once again
active.

AM SYNCRONOUS OPERATION

For general tuning and listening, normal AM is best. If,
however, the received signal sounds distorted, or
interference from adjacent stations is present, AM
synchronous should be engaged. The synchronous detector
in your receiver can greatly reduce the severe audio
distortion that can occur due to signal fading. The detector
also permits selectable tuning to either the upper or lower
sideband portion of an AM signal. Since most all AM (LW,
MW and SW) broadcasting generally uses double-sideband
transmission, detection of either of the two sidebands results
in full reception of the transmitted information. The
selectable sideband tuning and detection not only aids
reception by permitting tuning to the stronger or less
distorted sideband, but also permits rejection of the
sideband nearer to the interfering signal(s). For Example:
17
button which is one of the 'Direct-