Signal Searching; Selecting The Aspect Ratio; Temporarily Blanking The Screen - Hitachi CP-X385W User Manual

SIGNAL SEARCHING

POSITION RESET
ASPECT FREEZE ESC
MAGNIFY MUTE
ON OFF
VOLUME
SEARCH

SELECTING THE ASPECT RATIO

AUTO
MENU
KEYSTONE
ENTER
RESET
POSITION
ASPECT FREEZE ESC
MAGNIFY MUTE
ON OFF
VOLUME
SEARCH

TEMPORARILY BLANKING THE SCREEN

BLANK
STANDBY/ON
LASER
VIDEO RGB
AUTO
22
Press the SEARCH button
1
When you press the SEARCH button, the projector begins
searching for input signals. If it detects an input signal, the
search will cease and the projector will project the detected
signal. If the projector is unable to find an input signal at any of
its ports, it will return to the state it was in prior to the search.
SEARCH
Press the ASPECT button
1
ASPECT
RGB IN 1, RGB IN 2, COMPONENT VIDEO
(HDTV signals : 1125i (1035i/1080i), 750p)
4:3
VIDEO IN, S-VIDEO IN, COMPONENT VIDEO
(Non-HDTV signals : 525i, 525p,625i)
4:3 16:9
Press the BLANK button
1
The input signal screen is shut off, and a blank screen
appears. You can set the blank screen using the menu
(from the SCREEN menu, select BLANK). Press the BLANK
button again to remove the blank screen, and return to the
input signal screen.
BLANK
RGB IN 1 RGB IN 2
COMPONENT VIDEO
16:9
SMALL
VIDEO IN
S-VIDEO IN