Resetting Your Headset; Getting Started; Mounting The Headset On A Helmet - Cardo Systems scala rider G4 User Manual

4.4 RESETTING YOUR HEADSET

If your headset fails to respond despite repeated attempts, you
can reset your headset by charging it. After approximately 10
seconds, remove the headset from the charger and turn it on
again. Your headset should now respond as expected.

5. GETTING STARTED

5.1 MOUNTING THE HEADSET ON A HELMET

The Helmet clamp that includes your microphone and speakers
must first be mounted on left part of the helmet. Once mounted,
the headset unit can be attached or detached from the clamp at
any time.
There are two methods that can be used to attach the clamp to
the helmet:
Standard Method: Recommended for most helmet types.
Glue Plate Method: Recommended for hel-
mets to which the standard method cannot be
applied, using the Glue Plate included in the box.
Standard Method: Fastening the Clamp to
the Helmet
1. Use the enclosed Allen Wrench to loosen
the two screws on the Back Plate.
2. Slide the Back Plate between the internal
padding and the external shell of the
helmet.
3. Adjust the clamp's location so that the
microphone is located in front of the center
of your mouth, and then tighten the screws.
You may need to reposition the Clamp
repeatedly until you identify the best spot.
Glue Plate Method: Attaching the Clamp by way of glue
You have the option to glue the Helmet Clamp onto your hel-
met, when the above standard method cannot be used, or in
case you prefer to secure the Helmet Clamp with adhesive glue.
Caution: This process can be done only once!
NOTE: While we have no reason to believe that the gluing option might
negatively affect any helmet, Cardo does not assume any responsibility
to that effect, irrespective of its nature and circumstances. The Glue Plate
is offered as a free option that you may choose to use at your own risk
and subject to renouncement of any future claims.
1. Use the enclosed Allen Wrench to
remove both Allen screws and
release the Helmet Clamp's back
plate.
2. Determine the location on the helmet where the Helmet
Clamp must be attached.
3. Adjust the Helmet Clamp's location on the Helmet so that
Glue Plate
the microphone is located opposite the
center of your mouth. You may need to
reposition the Clamp repeatedly until you
identify the best spot. (Be sure to clean
the selected area prior to the gluing
process).
4. Use the pre-moistened Towlette to clean the helmet area
where you want to install the Glue Plate. Allow to dry
thoroughly.
5. Peel the foil cover from the Glue Plates' adhesive pad.
6. Place the Glue Plate into position according to #3. Press
firmly 15 seconds on all 3 parts of the Glue Plate.
scala rider ® G4 ™ Instructor Kit
7