Support; Notices - Cardo Systems scala rider G4 User Manual

3. Turn on the Trainee 2** headset and wait for a few seconds*
until the red light on the Trainee 2 unit flashes for two
seconds.
Now all trainee's headsets and Instructor's headset are con-
nected and ready for use.
If any headset goes out of range and is disconnected, once it
is back within range you may need to press the correspond-
ing Intercom Channel buttons to reconnect to the Intercom
call.
IMPORTANT NOTE
• In order to communicate with Trainee 2 headset, Trainee 1 headset
must be operational.
* This process may take up to one minute
** Refers to the scala rider G4 Instructor Kit package for 2 trainees

11. SUPPORT

For additional information please visit our website at
www.cardosystems.com
FAQ: www.cardosystems.com/faq
or contact us at: support@cardosystems.com
Phone:
USA and Canada: + 1-800-488-0363
International: +4989 450 36819

12. NOTICES

Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved
by the part responsible for compliance could void the user's authority to
operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that
may cause undesired operation of the device.
scala rider ® G4 ™ Instructor Kit
13