Reset Pairing (Delete All Pairing Data); Resetting Your Headset; Resetting Your Speakerphone; Using The Intercom - Cardo Systems scala rider G4 User Manual

9. RESET PAIRING (DELETE ALL PAIRING
DATA)
You can delete all of your pairings at any time as follows:

9.1 RESETTING YOUR HEADSET

1. For resetting any given headset, please make sure that the
remaining headsets are turned off.
2. With the headset turned ON, press and hold the Control
Button for at least six seconds until the Red and Blue Lights
begin rapidly alternating.
2. Press and hold the Volume Up Button for three seconds.
3. The Red and Blue Lights will flash five times simultaneously
and then the headset will turn off, confirming that Reset
was successfully completed.

9.2 RESETTING YOUR SPEAKERPHONE

1. Make sure that the Instructor's headset is turned off.
2. Ensure the speakerphone is on standby mode.
3. Press and hold the Volume Up and Volume Down Buttons
for ten seconds.
4. The Red and Blue Lights will flash five times simultaneously
and the speakerphone will be on Standby mode.

10. USING THE INTERCOM

10.1 INSTRUCTOR'S SPEAKERPHONE CAR OPTION

1. Turn on the speakerphone by pressing and holding the
Control Button until it flashes in blue.
2. Turn on the Instructor headset and wait for a few
seconds* until the red light on the Instructor's headset
flashes for two seconds.
12 scala rider ® G4 Instructor Kit
™
3. Tap CHANNEL A Button on the Instructor's headset and
wait until the blue light begins flashing twice every three
seconds. This will be followed by the Speakerphone's
confirmation tone.
4. Turn on the Trainee 1 headset and wait for a few seconds*
until the red light on the Trainee 1 unit flashes for two
seconds.
5. Turn on the Trainee 2** headset and wait for a few seconds*
until the red light on the Trainee 2 unit flashes for two
seconds.
Now all trainee headsets and the Instructor's headset are con-
nected and ready for use.
If any headset goes out of range and is disconnected, once it
is back within range you may need to press the correspond-
ing Intercom Channel buttons to reconnect to the Intercom
call.
IMPORTANT NOTES:
• In order to communicate with Trainee 2 headset, Trainee 1 headset
must be operational.
• If the connection with Instructor's headset is lost, the Speakerphone
will turn off automatically in 15 minutes.
* This process may take up to one minute
** Refers to the scala rider G4 Instructor Kit package for 2 trainees
10.2 INSTRUCTOR'S ALTERNATIVE INTERCOM OPTIONS
(HEADPHONE/HELMET)

Start with all headsets and the Speakerphone powered off.

1. Turn on the Instructor's headset.
2. Turn on the Trainee 1 headset and wait for a few seconds*
until the red light on the Trainee 1 unit flashes for two
seconds.