Connecting A Computer; Updating The Software - Sagem PVR 6200T UK User Manual

11. CONNECTING A COMPUTER

Only version PVR6600T has USB ports.
A computer (for example, a PC) can be connected to USB port B.
The photo partition of the Receiver is seen as a removable mass memory
on your computer. It is then possible to rename photos and albums, move
photos between albums and transfer them to and from the computer.
To view the changes made on the Receiver, place your equipment in
standby.
When you unplug the receiver from a computer, do it correctly: select "Remove the removable device"
in the menu bar on your PC.

12. UPDATING THE SOFTWARE

The receiver enters this mode when a new software version is supplied on the network after start-up.
The system goes back into standby and then restarts by itself.
A welcome picture is displayed.
Then the "Software update" screen opens.
You can postpone the downloading process by pressing the EXIT key. This process will be displayed again next
timeyou switch your receiver on.
Downloading starts when you press the key:
The screen becomes black.
The display indicates the download phases (0 to 4).
The user cannot carry out any operation during this process during some minutes (5 to 10).
Once the process is complete, the receiver will switch on automatically.
After the receiver has switched itself on, press the key
programme watched.
to quit the welcome screen and go back to the last
- 25 -
Port B