Appendix; Trouble Shooting - Edge Products Evo HT User Manual

A P P E N D I X
T R O U B L E T R O U B L E
Issue: My Evo HT does not
power up when plugged into
the OBDII port?
Solutions:
1. Your vehicle's OBDII port is pow-
ered through a fuse – the fuse may
be blown. (In most vehicles, this is
the same fuse shared by the cigarette
lighter)
2. Try the Evo HT on another vehicle
to make sure it powers up. If it does,
then the wiring on the vehicle you are
trying to program may be the issue
(See your dealer for service).
------------------------------------------
Issue: My Evo HT Says: "Non-
Stock File Detected..."
Solution:
1. Your vehicle may have been
programmed by another device. Use
that device to set your vehicle back to
stock before using the Evo HT.
----------------------------------------------
Issue: My programmer dis-
plays status G-6F?
Solution:
1. The error code is a 'General Data-
base Error'. It means your program-
mer does not have a complete data-
base. Refer to the "Getting Started"
section of this manual and update your
programmer.
----------------------------------------------
14
S H O O T I N G S H O O T I N G
Issue: When reading the ve-
hicle's trouble codes (DTCs),
I received a P1000 error code?
Solution:
P1000 is a DTC that sometimes ap-
pears after a vehicle is programmed or
the battery cables are unplugged from
the battery. It will automatically clear
after several drive cycles. It cannot
be removed using the 'DTC Clear'
function.
------------------------------------------
Issue: My vehicle has sev-
eral aftermarket part modi-
fi cations and after I pro-
gram with Edge Products,
the vehicle does not run well?
Solution:
An Evo HT programmer is designed
for stock vehicles (factory stock cali-
brations and stock engine & transmis-
sions). In some cases, upgrades like air
fi lters, shorty headers, cold air intakes,
or cat-back exhausts may not be sup-
ported.
----------------------------------------------
Issue: My programmer did not
complete programming and
went into recovery mode?
Solution:
Evo HT programmers are designed
with 'Recovery Mode' which means
if, for any reason, the programming
process does not fi nish, the program-
mer will automatically program your
vehicle back to the factory stock