Advertisement
If an extension cord is used:
- it must have an earth lead;
- take all necessary precautions to prevent anyone tripping
over it.
If the power supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
Plug the cord into a mains socket: the indicator light (10) comes
on and the appliance starts to heat up.
Never leave the appliance plugged in when not in use, except
for pre-heating.
Never run the appliance empty.
The appliance might make a slight noise when first switched
on.
Set the thermostat to the position indicated in the cooking table.
The position of the thermostat during pre-heating is the same as
that used for cooking.
Pre-heat the appliance for about 5 minutes.
Pre-heating is over when the indicator light switches off.
To preserve the non-stick properties of the coating, avoid
excessive pre-heating with the appliance empty.
On first use, there may be a slight odour and a little smoke
during the first few minutes. This is normal.
Never leave the appliance unattended when in use.
Cooking
After pre-heating, the appliance is ready for use.
To preserve the non-stick properties of the coating:
- as a preference, use a wooden spatula to turn the food over;
- never cut food directly on the plates.
Do not put any cooking utensils on the appliance to heat up.
Do not touch the metal parts of the appliance (grill plates,
support wire and handle of the upper electric unit) when it is
heating or operating, as they are very hot: use the handle and
wear oven gloves if necessary.
Do not move the appliance when in use.
Be extra careful when the appliance is used in the presence of
children.
Advertisement
