XM EDGE User Manual page 10

Vehicle Installation
Installing the Vent Mount:
1 Locate a vent with horizontal
louvers sturdy enough to hold your
PowerConnect Vehicle Dock and Radio .
2 If the vent louvers in your vehicle are
recessed, you may need to use the
longer vent clamps with the Vent Mount .
If so, remove the shorter vent clamps
and install the longer ones into the Vent
Mount . Be sure to observe the orientation of the vent clamps
as shown .
3 Push the Vent Mount onto the vehicle vent as shown (1) until it hooks on
the rear of the vent louver (2) .
Remove End Cap
Slide Extended Vent Clamps In
18
Extended Vent Clamps
Short Vent
Clamps
Slide Short Vent Clamps Out
Replace End Cap
4 Rest the foot against the bottom of the vent (2), and adjust the tilt of the
Vent Mount by repositioning the foot to a different adjustment hole (3) .
1
Dash
PUSH
Vent
Foot
Louver
To remove the Vent Mount, push the mount into the vent . Then lift up until
disengaged from the rear of the vent louver, and remove the Vent Mount .
2 3
Dash
Dash
HOOKED
Vent
Vent
19