Battery Pack; Tiller Console Fuse; Charger Power Cord Receptacle; Main Circuit Breaker (Reset Button) - Pride Mobility Go-Go Ultra X Owner's Manual

I V . Y O U R T R A V E L

BATTERY PACK

Your Travel Scooter is equipped with an innovative, easy to remove battery pack. A handle on the top of the
battery pack makes it easy to lift the pack off of the Travel Scooter with one hand. The battery pack contains two
batteries, the charger power cord receptacle, the main circuit breaker (reset button), and the battery pack fuse.
See figure 7.
BATTERY PACK
BATTERY PACK FUSE
CHARGER POWER
CORD RECEPTACLE
Figure 7. Battery Pack

Charger Power Cord Receptacle

The 3-pin end of the charger power cord plugs into this receptacle.

Main Circuit Breaker (Reset Button)

When the voltage in your Travel Scooter's batteries becomes low or the Travel Scooter is heavily strained because
of excessive loads or steep inclines, the main circuit breaker may trip to protect the motor and electronics from
damage.
The main circuit breaker reset button pops out when the breaker trips.
When the breaker trips, the entire electrical system of your Travel Scooter shuts down.
Allow a minute or two for your Travel Scooter's electronics to "rest."
Push in the reset button to reset the main circuit breaker.
If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may also
need to have your authorized Pride Provider perform a load test on your Travel Scooter's batteries.
If the main circuit breaker trips repeatedly, see
your authorized Pride Provider for service.

TILLER CONSOLE FUSE

The fuse located under the battery pack protects the
tiller console electronics. See figure 8. In the event
any component of the tiller console is not responding,
check this fuse. See IX. "Basic Troubleshooting" for
fuse replacement instructions.
20
www.pridemobility.com
S C O O T E R
Figure 8. 3-Amp Tiller Console Fuse
BATTERY PACK HANDLE
MAIN CIRCUIT BREAKER
(RESET BUTTON)
Go-Go Ultra X