Getting Off Your Travel Scooter; Power Down Timer Feature - Pride Mobility Go-Go Ultra X Owner's Manual

The electromechanical disc park brake automatically disengages and the Travel Scooter accelerates smoothly
to the speed you preselected with the speed adjustment dial.
Pull on the left handgrip to steer your Travel Scooter to the left.
Pull on the right handgrip to steer your Travel Scooter to the right.
Move the tiller to the center position to drive straight ahead.
To stop, slowly release the throttle control lever. The electronic brakes will automatically engage when your
Travel Scooter comes to a stop.
NOTE: Your Travel Scooter's reverse speed is slower than that of the forward speed you preset with the
speed adjustment dial.
GETTING OFF OF YOUR TRAVEL SCOOTER
1. Bring your Travel Scooter to a complete stop.
2. Remove the key from the key switch.
3. Disengage the seat rotation lever and rotate the seat until you are facing toward the side of your Travel Scooter.
4. Make certain that the seat is locked securely in position.
5. Carefully and safely get out of the seat and stand to the side of your Travel Scooter.
6. You can leave the seat facing to the side to facilitate boarding your Travel Scooter next time.

POWER DOWN TIMER FEATURE

Your Travel Scooter is equipped with an energy saving automatic power down timer feature designed to
preserve your Travel Scooter's battery life. If you mistakenly leave the key in the key switch and in the "on"
position but do not use your Travel Scooter for approximately 20 minutes, the Travel Scooter's controller
shuts down automatically.
If the power down timer feature takes effect, perform the following steps to resume normal operation.
1. Remove the key from the key switch.
2. Reinsert the key and power up your Travel Scooter.
Go-Go Ultra X
V I . O P E R A T I O N
www.pridemobility.com
27