SYMPTON
Won't heat- - no indicator
lights
One or more section
won't heat—or not hot
enough
One or more section too
hot
Element assy loose, or
difficult to raise or lower
Element assy does not
latch in up position
POSSIBLE CAUSE
Not plugged in, or
Circuit breaker tripped.
Temperature control not set
240V unit run on 208V
Damaged component or wiring
Temperature control not set
208V unit run on 240V
Damaged component or wiring
Damaged hinge
(see page 7 for precautions)
Damaged support rod assembly
11
TROUBLESHOOTING SUGGESTIONS
SUGGESTED REMEDY
Check plug
Check / reset circuit breaker
Set temperature control knob to
desired temperature
Verify proper voltage
Contact an Authorize Wells
Service Agency for repairs
Set temperature control knob to
desired temperature
Verify proper voltage
Contact an Authorized Wells
Service Agency for repairs
Contact an Authorized Wells
Service Agency for repairs
Contact an Authorized Wells
Service Agency for repairs
There are no user-serviceable
components in this unit.
In all instances of damage or
malfunction, contact your
Authorized Wells Service
Agency for repairs.