Wheel Replacement
always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
if you damage one or more wheels or they are
worn out, you can easily replace the wheels.
tools Needed
hex Wrench 5mm .............................................. 1
to replace a wheel:
1.
disCoNNECt thE poWEr FEEdEr
FroM poWEr!
Model g4179
⁄
hp power Feeder
1
2
2.
Using a 5mm hex wrench, remove the two
wheel retaining cap screws (Figure 15).
Qty
Figure 15. Wheel replacement.
3.
swap the old wheel with the new.
4.
reinstall the two cap screws, and tighten in
an alternating pattern until the wheel is sec-
cure.
Cap
screw
-21-