Wells WRG-Series Owner's Manual page 6

INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
RISK OF
PERSONAL INJURY
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
WARNING:
ELECTRIC
SHOCK HAZARD
DO NOT open any access
panel which requires the use
of tools. Failure to follow this
warning can result in severe
electrical shock.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or
energize this appliance until
all installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
IMPORTANT:
This appliance requires a
properly installed and
grounded NEMA 5-15R or
NEMA 6-15R receptacle.
Contact a licensed electrician
to install the proper circuit if
one is not available.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
Appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
COMPONENTS
DRIP TRAY
LITERATURE PACKAGE
SETUP
The WRG-Series Hot Dog Roller Grill is designed to set on top of the
matching WBC-Series Hot dog Bun Cabinet. Otherwise, set the
appliance only on a firm, level, non-combustible surface. Verify local
codes for requirements. Concrete, tile, terrazzo or metal surfaces are
recommended. Metal over combustible material may not meet code for
non-combustible surfaces.
Verify that the unit sits firmly ON ALL FOUR LEGS. With a spirit level,
check that the appliance is level front-to-back and side-to-side. With
the adjustable legs, adjust as required to level the appliance. All four
legs must be adjusted to firmly contact the floor in order to prevent
tipping.
Avoid storing flammable or combustible materials in, on or near the
appliance.
ELECTRICAL INSTALLATION
This appliance requires a properly installed and grounded NEMA 5-15R
or NEMA 6-15R receptacle. The ground prong (large round pin) of the
power cord is part of a system to protect you in the event of equipment
damage. Never cut off the ground prong nor twist a blade to fit an
existing electrical receptacle Contact a licensed electrician to install
the proper circuit if one is not available.
4