Table of Contents
Advertisement
[STEP 21
[STEP 31
b. Control Pedal
c. Expression Pedal
8
Select a Bank.
Press the Bank Pedale and confirm that the Bank DisplayCi) is blinking.
Then press a relevant Number Pedal
0
to select the Bank you want. The
selected Bank is shown in the Bank DisplayeD.
~~lfil
~ ~ ~
lQ1
ral-
t--
2. The Bank Display
flashes.
~
U]
~
I
[j
.~
~
I
I
L - l , Press the Bank Pedal.
I
3. Select a Bank using the relevant Number Pedal.
Press the relevant Number Pedal.
*
To cancel the Bank selecting mode, press the Bank Pedal (l) while the
Bank DisplavG) is blinking.
Select a Number.
Press the relevant Number Pedal. to select the Number you want. The
corresponding Number IndicatorG will light up.
i
Press the Number Pedal that you wish to select.
The Control Pedal functions differently depending on the type of device you
use. Read the owner's manual for the device, and if necessary, change the
position of the Mode Selector Switch
e
on the rear of the unit.
*
When the Mode Selector SWitchO is set to the "I" position and the Control
PedalO is turned on, selecting a Patch will automatically turn off the
Control Pedal
f).
Two expression pedals can be connected to the Expression Pedal Jacks
IEXPl
e
and EXP201 at the same time.
*
The EXP2
0
jack cannot be used with some types of devices.
*
Depending on the external device you use, the expression .pedal will
function differently. Read the owner's manual for the relevant unit.
Advertisement
Table of Contents
