Maintenance; Care And Cleaning; Metal Rack; Cleaning The Grease Filters - Amana MVH240E Owner's Manual & Installation Instructions

CARE AND CLEANING

For best performance and safety, keep the oven clean
inside and outside. Take special care to keep the inner
door panel and the oven front frame free of food or
grease build-up.
Never use abrasive cleaners or pads. Wipe the
microwave oven inside and out, including the hood
bottom cover, with a soft cloth and a warm (not hot)
mild detergent solution. Then rinse and wipe dry. Use a
chrome cleaner and polish on chrome, metal, and
aluminum surfaces. Wipe spatters immediately with a
wet paper towel, especially after cooking chicken or
bacon. Clean your oven weekly or more often, if
needed.

METAL RACK

Wash the metal rack with a mild soap and a soft or
nylon scrub brush. Dry completely.
Do not use abrasive scrubbers or cleaners to clean
rack.

CLEANING THE GREASE FILTERS

The grease filters should be removed and cleaned
often, at least once a month.
1. To remove grease filters, slide each
filter to the side. Pull filters downward
and push to the other side. The filter will drop out.
2. Wash in dishwasher or soak grease filters in hot
water and a mild detergent. Rinse well and shake to
dry. Do not use ammonia. The aluminum will
darken filter.

MAINTENANCE

3. To reinstall the filters, slide it into the side slot, then
push up and toward oven center to lock.
the filters in place.

CHARCOAL FILTER REPLACEMENT

If your oven is vented inside, the charcoal filter should
be replaced every 6 to 12 months, and more often if
necessary. The charcoal filter cannot be cleaned. To
order a new charcoal filter, contact the Parts
Department at your nearest Authorized Service Center
or call Amana at 1-800-843-0304(inside U.S.A) 1-319-
622-5511(outside U.S.A).
Order Charcoal Filter kit # : MVHRK2.
1. Disconnect Power to oven.
2. Remove the two vent grille mounting screws.
(2 middle screws)
3. Tip the grille forward, then lift it out.
4. Remove old filter.
5. Slide a new charcoal filter into place. The filter
should rest at the angle shown and set the clock.
6. Slide the bottom of the vent cover into place. Push
the top until it snaps into place. Replace the
mounting screws. Turn the power back on at the
main power supply and set the clock.
- 27 -
CAUTION
Do not operate the hood without