Storage - WAGNER Paint Crew Owner's Manual

S -T S
HORT ERM TORAGE
Follow these steps when using LATEX PAINTS ONLY. If using
materials that are oil-based, follow the long-term storage steps.
S
HUTDOWN
1. Perform all the steps of the
PROCEDURE
(page 5).
2. Pour 1/2 cup water slowly on top of the paint to prevent it
from drying. Replace the hopper lid.
3. Wrap the spray gun assembly in a damp cloth and place it in
a plastic bag. Seal the bag shut.
4. Unplug the sprayer.
5. Place the sprayer in a safe place out of the sun for short-
term storage.
S
TARTUP
1. Remove the gun from the plastic bag and stir the water into
the paint.
2. Check to be sure the
PRIME/SPRAY knob is set
to PRIME.
3. Plug sprayer in and turn
the switch to ON.
4. Turn the PRIME/SPRAY
knob to SPRAY.
5. Test the sprayer on a
practice piece and begin
spraying.
© 2003 Wagner Spray Tech - All rights reserved.
S
TORAGE
( 16
UP TO HOURS
PRESSURE RELIEF
SPRAY
PRIME
) P
REPARING THE
T S
ERM TORAGE
1. Make sure you have already completed the
pages 9-10.
2. Remove the inlet filter. You may need to use a screwdriver
to pry it loose.
Inlet
filter
3. Pour approximately two ounces of light household oil into
the inlet valve.
Inlet
valve
4. Remove hose from outlet valve, place a rag over the outlet
valve, and turn the switch ON. Let the unit run for five seconds.
5. Switch the pump OFF.
6. Replace the inlet filter and push the tab on the filter.
7. Wipe the entire unit, hose and gun with a damp cloth to
remove accumulated paint.
8. Replace the high pressure hose to the outlet valve and
replace the hopper lid.
11 Customer Service: 800-328-8251
S L
PRAYER FOR ONG
Cleanup
Tab
English
-
steps on