WAGNER Paint Crew Owner's Manual page 5

B
EFORE YOU
L
OCKING AND UNLOCKING THE GUN
WARNING
Always lock the trigger off when attaching the spray tip or
when the spray gun is not in use.
L
OCKING THE GUN
The gun is secured when
the trigger lock is at a 90°
angle (perpendicular) to the
trigger in either direction.
U
NLOCKING THE GUN
To unlock the gun, turn the
trigger lock to be in line with
the trigger.
The spray tip SHOULD NOT be attached until after the
sprayer and spray hose has been purged and primed.
P
LUGGING IN THE SPRAYER
1. Check that the ON/OFF
switch is in the OFF
postion.
2. Plug the sprayer into a
heavy duty grounded
extension cord (refer to
Important Electrical
Information, page 3).
P
RESSURE RELIEF PROCEDURE
WARNING
Be sure to follow the pressure relief procedure
shutting the unit off FOR ANY PURPOSE. This procedure is
used to relieve pressure from the spray hose.
1. Lock the spray gun off and
flip the ON/OFF switch to
the OFF position.
2. Turn the PRIME/SPRAY
knob to PRIME.
3. Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4. Lock the spray gun.
© 2003 Wagner Spray Tech - All rights reserved.
B --
T
HIS PAGE CONTAINS INFORMATION THAT WILL BE
EGIN
REPEATED THROUGHOUT THE MANUAL
E
MPTYING THE
Follow these instructions if the hopper is filled with material
and 1) your sprayer malfunctions or 2) you finish your
spraying project without using all the material in the hopper.
1. Perform all the steps of the
2. Remove the lid from the hopper.
3. Grab top handle of the sprayer with one hand, grab rear
handle with the other.
4. Lift and tilt the sprayer so that material will pour from one of
the front corners of the hopper and into its original container.
The unit, when filled with
spraying material, can be
heavy. Make sure to lift
with your legs and not your
back in order to reduce the
when
P
AINT
It is recommended that in order to avoid premature tip and filter
clogging you should strain your paint before spraying. Follow
manufacturer's recommendations.
C
HOOSING THE
Use the proper gun filter based on the tip size being used.
Part No.
0154918
0154675
5 Customer Service: 800-328-8251
H
OPPER
Pressure Relief Procedure
Top
handle
Front
corners
WARNING
Make sure your floors and
furnishings are protected
with drop cloths to avoid
risk of injury.
S
TRAINING
C S
ORRECT
Tip Size Filter Mesh
Type Number
.011 Extrafine 180 mesh
0.084 mm
.013 - .015 Fine 100 mesh
0.140 mm
English
.
(page 5).
Rear
handle
CAUTION
property damage.
G F
PRAY UN ILTER
Color of Qty.
Filter
Body
red 2 pack
yellow 2 pack