Niles iRemote TS Quick Install Manual page 13

iRemotetS HouSe mode: SYStem
deSiGN coNSideRAtioNS
Locating the iRemoteTS
The iremoteTS consists of three parts: the handheld remote, the
charging base, and an inline power supply that is connected
to the charging base. When in the house mode, the handheld
remote can be carried throughout the house. When not in use,
it should be placed back in the charging base. The charging
base requires a nearby un-switched AC power outlet. Since the
handheld remote is fully operational while in the charging base,
we recommend that you locate the iremoteTS in a place where
the touch screen is visible and can be used.
Wiring Termination Diagram
The CAT-5 cable used to connect the master Charging Base to the
IntelliControl ICS modular multiZone receiver must be terminated
with rJ-45 connectors using the T-568A pinout configuration
as follows:
Pin #
1
2
3
4
5
6
7
8
Note: TX+ = transmit, rX+ = receive, UI = User Interface.
Figure 8. IntelliControl ICS rJ-45 Pinout and checklist
1 2 3 4 5 6 7 8
Pin1
g G o B b O br BR
T-568A
Description
TX+
TX–
rX+
Ir Signal
Ir Ground
rX–
UI Power
UI Ground
www.nilesaudio.com
(coNt'd)
1 2 3 4 5 6 7 8
g G o B b O br BR
T-568A
Color Code
White/Green
Green
White/orange
Blue
White/Blue
orange
White/Brown
Brown
11