JL Audio e110 Owner's Manual page 8

SPECIAL CONSIDERATIONS FOR BUILT-IN INSTALLATIONS
Th e E-Sub can be integrated into custom cabinetry by following a few
simple guidelines.
1) Allow 4 inches (10 cm) of clear space behind the E-Sub's amp panel for
adequate cooling and connector clearance.
2) On all other sides (except the bottom), allow at least 2 inches
(5 cm) clearance for adequate ventilation.
3) While the E-Sub generally runs only warm during spirited operation, we do
recommend that adequate heat vents are included in any custom cabinet which
encloses the E-Sub. A pair of 3 inch (7.5 cm) diameter vents near the bottom of
the cabinet and near the top of the cabinet, will allow cool air to circulate over the
amp panel of your E-Sub subwoofer system keeping it cool and happy.
4) Your E-Sub subwoofer is capable of moving substantial quantities of
air. If the front of the E-Sub is covered by a custom grille, the grille
must have AT LEAST 85 square inches (548 sq.cm.) of vent area for
the e112, and AT LEAST 60 square inches (386 sq.cm.) for the e110.
Th ese areas are equal to the woofer cone area for each model and will
ensure that the E-Sub's output is not choked by the custom cabinet.
Page 8
Rear-view of cabinet install:
2 in. min.
VENT
Warranty void if serial number is
removed, altered or defaced.
L L
CH. 2 CH. 1 SERIAL NUMBER:
(R) (L)
Grounded
R R
Isolated Built in USA
LINE LINE with domestic and
INPUTS OUTPUTS HIGH LEVEL INPUTS imported components
VENT
VENT
2 in.
min.
VENT
| e110 & e112