JL Audio e110 Owner's Manual page 20

RECEIVER / PROCESSOR
PRE OUT
FRONT L REAR CENTER
FRONT R REAR SUB
L
R
INPUTS
L
R
E-SUB TOP CONTROL PANEL (#2)
INPUTS
WARNING! TURN OFF THE E-SUB(S) AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
Page 20
E-SUB TOP CONTROL PANEL (#1)
L
CH. 2 CH. 1
(R) (L)
Grounded
R
Isolated
LINE LINE
HIGH LEVEL INPUTS
OUTPUTS
E-SUB REAR PANEL (#1)
L
CH. 2 CH. 1
(R) (L)
Grounded
R
Isolated
LINE LINE
HIGH LEVEL INPUTS
OUTPUTS
E-SUB REAR PANEL (#2)
SYSTEM CONNECTION DIAGRAM 2:
Multiple E-Subs to Home Theater
Receiver or Home Theater Preamp/
Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer line-level output.
To greatly simplify the connection
of multiple subwoofers in a single home
theater system, E-Subs include a pass-
through line output feature. Th is allows
an input signal connected to one E-Sub to
be passed from that E-Sub to a second one,
and from the second E-Sub to a third, etc.
When connecting a mono subwoofer
output to multiple E-Subs, you only need
to connect to one of each E-Sub's "Line
Inputs" (Left or Right). Run an audio
interconnect cable from the receiver/pre-
pro's subwoofer output to one "Line Input"
of the fi rst E-Sub in the system. Th en run
a second audio cable from that E-Sub's
corresponding "Line Output" to one "Line
Input" of the next E-Sub in the system, as
shown in the diagram. Additional E-Subs
can be added using the same method.
IMPORTANT
You must turn the E-Sub's "Crossover"
off to use the pass-through signal feature,
allowing the receiver/pre-pro to perform
crossover/bass-management functions.
Make sure the "Crossover" switch on the
top control panel of the E-Sub is in the "off "
position to use this connection method.
Alternative Method:
If running cables from one E-Sub
to the next is not practical due to the
physical layout of the E-Subs relative
to the receiver/pre-pro, you can use a
Y-Adaptor cable (splitter) to split the
receiver/pre-pro output signal to multiple
audio interconnect cables, each feeding a
separate E-Sub.
Some receivers and preamp/processors
off er multiple subwoofer outputs, which
can also be used to connect multiple
E-Subs. Refer to the manual of your
receiver/pre-pro for details.
WARNING
| e110 & e112