JL Audio e110 Owner's Manual page 21

SYSTEM CONNECTION DIAGRAM 3:
One E-Sub in Mono to
Two-Channel Audio System
When connecting a single E-Sub in
mono to a two-channel audio system you
will use both the "Left " and the "Right"
"Line Inputs" of the E-Sub and you will
engage the E-Sub's active crossover
by selecting the "on" position on the
"Crossover" switch located on the top
control panel.
Th e internal active crossover will apply
low-pass fi ltering to feed the subwoofer's
internal amplifi er with a summed L+R
signal. It will also high-pass fi lter the input
signal and send it to the satellite amplifi er
via the "Line Outputs" jacks. Th is creates
a true two-way crossover that greatly
improves the overall performance of your
audio system by preventing the subwoofer
and satellite speakers from playing the
same frequency range, and by liberating
the satellite amplifi er and speakers from
the burden of reproducing power hungry,
distortion-inducing low-frequencies.
Use good-quality audio interconnect
cables with RCA-type connectors to make
these connections.
WARNING
| e110 & e112
PRE-AMPLIFIER
OUTPUTS
R L
L
–
INPUTS
R
SATELLITE AMPLIFIER
WARNING! TURN OFF THE E-SUB(S) AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
E-SUB TOP CONTROL PANEL
L L
CH. 2
(R)
Grounded
R R
Isolated
LINE LINE
HIGH LEVEL INPUTS
INPUTS OUTPUTS
E-SUB REAR PANEL
SPEAKER OUTPUTS
L R
+ – +
CH. 1
(L)
(L) (R)
TO SATELLITE
SPEAKERS
Page 21