JL Audio e110 Owner's Manual page 22

PRE-AMPLIFIER
OUTPUTS
R L
L
R
LINE
INPUTS
L
R
LINE
INPUTS
WARNING! TURN OFF THE E-SUB(S) AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
Page 22
SATELLITE AMPLIFIER
L
INPUTS
R
L
CH. 2 CH. 1
(R) (L)
Grounded
R
Isolated
LINE
HIGH LEVEL INPUTS
OUTPUTS
E-SUB REAR CONTROLS (LEFT)
L
CH. 2 CH. 1
(R) (L)
Grounded
R
Isolated
LINE
HIGH LEVEL INPUTS
OUTPUTS
E-SUB REAR CONTROLS (RIGHT)
SYSTEM CONNECTION DIAGRAM 4:
Two E-Subs in Stereo to
Two-Channel Audio System
SPEAKER OUTPUTS
When connecting two E-Subs in
L R
– + – +
stereo to a two-channel audio system you
will assign one E-Sub to the left channel
and the other one to the right channel.
You will engage each E-Sub's active
crossover by selecting the "on" position on
the "Crossover" switch located on the top
control panel.
Th e internal active crossover will
apply low-pass fi ltering to feed the
subwoofer's internal amplifi er. It will also
(L) (R)
high-pass fi lter the input signal and send
TO SATELLITE
SPEAKERS
it to the satellite amplifi er via the "Line
Outputs" jack corresponding to the input
channel used. Th is creates a true two-
way crossover that greatly improves the
overall performance of your audio system
by preventing the subwoofer and satellite
speakers from playing the same frequency
range, and by liberating the satellite
amplifi er and speakers from the burden
of reproducing power hungry, distortion-
E-SUB TOP CONTROL PANEL
(LEFT)
inducing low-frequencies.
You will only use one "Line Input" on
each E-Sub (left or right). First, connect
the left output of your preamplifi er to the
"Line Input" of the E-Sub designated as
the left subwoofer, and then connect that
E-Sub's "Line Output" to the left input of
your satellite amplifi er.
E-SUB TOP CONTROL PANEL
(RIGHT)
Th en, connect the right output of your
preamplifi er to the "Line Input" of the
E-Sub designated as the right subwoofer,
and then connect that E-Sub's "Line
Output" to the right input of your satellite
amplifi er.
Use good-quality audio interconnect
cables with RCA-type connectors to make
these connections.
WARNING
| e110 & e112