Recognition Systems HandPunch 2000 Installation And Operation Manual page 7

HandPunch 2000 Installation and Operations Manual
SUPERVISORS/ADMINISTRATORS OPERATING GUIDE
The HandPunch Command Mode is used to add and remove employees from the
system, and perform other system management and service operations. This section of
the manual describes those commands that will commonly be used by work group
supervisors in daily operations of the HandPunch. The command mode is only
accessible to people who are enrolled as supervisors.
Command Mode Overview
The command mode has five groups of menus. Access to each group is controlled by an
individual password.
ENROLLMENT
SECURITY
DEFAULT
PASSWORD 4
PASSWORD 5
SPECIAL ENROLL ADD EMPLOYEE
ADD SUPERVISOR
REMOVE EMPLOYEE
Passwords
Access to the each command group requires a password. A new and unique password
can be assigned to each of the (5) Command Groups from the host computer. You must
exit one command group to enter another. The factory default passwords are shown in
the table below.
6
COMMAND MODE STRUCTURE
MANAGEMENT
DEFAULT DEFAULT
PASSWORD 3
LIST EMPLOYEES
SET EMPLOYEE DATA
SPECIAL ENROLL GROUP
ENROLLMENT GROUP
MANAGEMENT GROUP
SETUP GROUP
SERVICE GROUP
SETUP
DEFAULT
PASSWORD 2 PASSWORD 1
SET LANGUAGE CALIBRATE
SET DATE FORMAT STATUS DISPLAY
SET TIME & DATE
SET ADDRESS
SET ID LENGTH
SET SERIAL
5
4
3
2
1
SERVICE
DEFAULT