General Setup - Recognition Systems HandPunch 2000 Installation And Operation Manual

HandPunch 2000 Installation and Operations Manual
SET LANGUAGE
* NO YES #
SET DATE FORMAT
* NO YES #
SET TIME AND DATE
* NO YES #
SET ID LENGTH
* NO YES #
SET ADDRESS
* NO YES #
SET SERIAL
* NO YES #

General Setup

The following is a list of typical set up items
needed before enrolling users. The detail for each
menu follows this overview.
Note: It is not necessary to leave the command
mode after each item is set as shown in the detailed
descriptions.
Set Language
Set Date Format
The first two items in the setup menu allow the
reader to be "localized" for a variety of countries.
Set Time and Date
For units not networked to a PC it is important to
set the time and date. Units networked to a PC
typically receive the time and date from the PC.
Set ID Length
Setting the ID length can reduce the number of
keystrokes needed to enter the ID number by
eliminating the use of the # or ENTER key to
complete ID number entry.
Set Address
The default setting (1) is typical for this
application. Change only if your application
requires a different address.
Set Serial
Set the network communcation baud rate The
default is 9600 bps.
9