Table of Contents
Advertisement
OHP 5000 User Manual
Other Functions
Adding Additional Memory
Remote Trigger
Location -- rear panel
Connection -- 2.5 mm mini jack
Operation -- by connecting a momentary switch to this jack, the
unit will play audio content from memory when triggered.
Content will play through once and then reset, ready for next
trigger sequence.
Auxiliary In
Location -- rear panel next to TRIGGER jack
Connection -- 3.5 mm mini jack
Operation -- connect audio cable from the LINE OUT or
"headphone out" jack of any external audio source to the AUDIO
IN jack. Audio from an external source (CD, radio, tape or PC) can
be recorded to the unit's memory without using the unit's
integrated CD.
Configuration
The OHP 5000 comes standard with 8 minutes of flash memory.
Memory can be expanded to 16, 24 or 32 minutes by adding
memory modules in 8-minute increments. Memory modules can be
placed into 3 available memory expansion slots located under the
memory expansion access panel door.
Installation
1. Turn power switch to OFF position.
2. Open player lid.
3. Remove memory expansion access panel door located left of the
CD drive.
4. Carefully insert the 24-pin memory module chip in an open
expansion slot (beginning at the top of the unit).
5. Turn power switch to ON position.
LCD will display the additional memory in the MEM AVAIL counter.
6
Advertisement
Table of Contents
